HARLEY
Subcategories
Active filters
Polished braided crossover fuel line with crystal-clear jacket, compression fittings and two seal sizes; made in the USA.
Replacement fiber and steel clutch plates. For use with Barnett Scorpion clutches. Made in the U.S.A.
Replacement clutch plate set for Scorpion clutches. Made in the U.S.A.
Two-piece direct-fit design for accurate installation on non-ABS bikes. Crystal clear jacket resists scuffing and discoloration. AN-3 connections for easy fitment. One upper and one lower kit required per side; two kits per bike.
Low-profile lock-up conversion kit increases clutch capacity with stainless steel weighted arms and three spring sets for adjustable, smoother engagement. Bolt-on installation.
Complete braided cable and brake-line installation kit with hardware and switch wiring extensions; DOT-compliant and assembled in the USA.
Complete installation kit with matching braided cables and brake lines for a finished, reliable setup.
Includes necessary hardware, copper crush washers, and DOT-compliant brake lines; assembled in the USA.
Complete kit with matched braided cables, brake lines, hardware, and switch wiring for handlebar installations using risers.
Complete installation kit with matching braided cables and brake lines. Includes throttle and idle cables or throttle-by-wire extensions, clutch or hydraulic clutch line, brake lines, hardware, washers, and any required switch wiring or turn signal extension. Meets OE specs and DOT FMVSS-106; assembled in the USA.
Complete kit with matching braided cables and brake lines; includes cables, brake lines, hardware, and wiring for seamless installation. DOT FMVSS‑106 compliant and assembled in the USA.